Search results for "Yttria-stabilized zirconia"
showing 10 items of 30 documents
Evaluation of nano/submicro pores in suspension plasma sprayed YSZ coatings
2019
Abstract Nano-submicro pores could considerably influence the coating performances and thus should be properly designed for the intended applications. However, it is challenging to characterize accurately such small pores in coatings. In this study, YSZ coatings were firstly manufactured by suspension plasma spray (SPS) and the nano-submicro pores in as-prepared coatings were investigated using Ultra-small-angle X-ray scattering (USAXS). Afterwards, a multivariate analysis on the effect of five different process parameters was carried out. The two main results showed that: 1) the nano-submicro pores content in coatings has a negative correlation with suspension mass load and powder size, an…
Measurement of the activation energies of oxygen ion diffusion in yttria stabilized zirconia by flicker noise spectroscopy
2019
The low-frequency noise in a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope (CAFM) probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. YSZ is a promising material for the memristor application since it is featured by high oxygen ion mobility, and the oxygen vacancy concentration in YSZ can be controlled by varying the molar fraction of the stabilizing yttrium oxide. Due to the low diameter of the CAFM probe contact to the YSZ film (similar to 10nm), we are able to measure the electric current flowing through an individual filament both in the low resistive state (LRS) and in the high r…
Preparation by radio-frequency magnetron co-sputtering and characterization of thin films of lanthanum–strontium ferromanganites
2005
Abstract (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ films with y = 0, 0.2, 0.5, 0.8 and 1, a few hundred nanometers thick, were deposited onto polycrystalline yttria-stabilized zirconia YSZ by a magnetron co-sputtering technique using individual targets of La 0.8 Sr 0.2 MnO 3 and La 0.8 Sr 0.2 FeO 3 . The deposition parameters, substrate temperature and gas pressure, were studied by scanning electron microscopy, energy dispersive X-ray spectrometry, X-ray diffraction and interferential microscopy for their effects on the morphological, chemical, topographic and crystallographic properties of films and YSZ-film interfaces. (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ thin films were found to be …
Thermodynamics of ABO3-Type Perovskite Surfaces
2011
The ABO3-type perovskite manganites, cobaltates, and ferrates (A= La, Sr, Ca; B=Mn, Co, Fe) are important functional materials which have numerous high-tech applications due to their outstanding magnetic and electrical properties, such as colossal magnetoresistance, half-metallic behavior, and composition-dependent metal-insulator transition (Coey et al., 1999; Haghiri-Gosnet & Renard, 2003). Owing to high electronic and ionic conductivities. these materials show also excellent electrochemical performance, thermal and chemical stability, as well as compatibility with widely used electrolyte based on yttrium-stabilized zirconia (YSZ). Therefore they are among the most promising materials as …
EXAFS study of the local structure of crystalline and nanocrystalline Y2O3using evolutionary algorithm method
2015
Temperature-dependent local structure and lattice dynamics of yttria (Y2O3) were studied by X-ray absorption spectroscopy. Novel method, which combines the reverse Monte Carlo and evolutionary algorithm techniques, was applied for the analysis of extended X-ray absorption fine structure at the Y K-edge. This approach allowed us to reconstruct 3D atomic structure models of crystalline and nanocrystalline Y2O3.
Temperature-dependent EXAFS study of the local structure and lattice dynamics in cubic Y2O3
2016
The local structure and lattice dynamics in cubic Y2O3were studied at the YK-edge by X-ray absorption spectroscopy in the temperature range from 300 to 1273 K. The temperature dependence of the extended X-ray absorption fine structure was successfully interpreted using classical molecular dynamics and a novel reverse Monte Carlo method, coupled with the evolutionary algorithm. The obtained results allowed the temperature dependence of the yttria atomic structure to be followed up to ∼6 Å and to validate two force-field models.
Synthesis of yttrium aluminum garnet nanoparticles in confined environment II: Role of the thermal treatment on the composition and microstructural e…
2017
Abstract Nanoparticles of yttrium aluminum garnet (YAG, Y 3 Al 5 O 12 ) have been obtained by thermal treatments, at several temperature in the range 400–950 °C, of the precursors synthetized via co-precipitation in water in oil microemulsion. The obtained nanoparticles have been characterized by means of X-ray Diffraction and Transmission Electron Microscopy coupled with Energy Dispersive X-ray Spectroscopy (EDS) and Select Area Electron Diffraction (SAED). Results show the phase evolution occurring to obtain not aggregated nanoparticles of YAG phase. A possible growth mechanism of YAG nanoparticles is discussed on the basis of observed particle microstructure and morphology. The results i…
Synthesis of yttrium aluminum garnet nanoparticles in confined environment III: Cerium doping effect
2018
Abstract Cerium yttrium aluminum garnet (Ce:YAG, CexY3-xAl5O12) nanoparticles doped with different cerium amount were obtained by calcining the precursors synthesized via co-precipitation in w/o microemulsion for 1 h at 900 °C. The structural and morphological properties were investigated by using X-ray Diffraction (XRD), Infrared Spectroscopy (IR) and Transmission Electron Microscopy (TEM) coupled with Energy Dispersive X-ray Spectroscopy (EDS) in order to investigate the effect of doping level on formation and microstructure of obtained nanoparticles. It was found that the composition of the final products strongly depends on the concentration of cerium. The formation of single YAG phase …
High temperature reactivity of nickel aluminide diffusion coatings
2008
Abstract The high-temperature oxidation behaviour of nickel aluminides has been studied at 900 °C in air under atmospheric pressure. Yttria doped and undoped specimens of nickel were aluminised and then oxidised for 100 h under isothermal and cycling conditions. The results showed that when yttria is added by metal-organic chemical vapour deposition technique prior to the aluminisation process, it increased the oxidation rate of aluminised nickel, but improved the oxide scale adherence under cyclic conditions. The effects of yttria on the scale morphology, oxidation behaviour and scale spallation tendency are discussed based on the experimental results, using X-ray diffraction (XRD), scanni…
Influence of oxygen ion elementary diffusion jumps on the electron current through the conductive filament in yttria stabilized zirconia nanometer-si…
2021
Abstract The structure of the electron current through an individual filament of a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. Usually, such investigation is performed by the analysis of the waveform of this current with the aim to extract the random telegraph noise (RTN). Here, we suggest a new indirect method, which is based on the measurement of the spectrum of the low-frequency flicker noise in this current without extracting the RTN, taking into account the geometrical parameters of the filament. We propose that the flicker no…